28 Apr '13, 7pm

Wristwatch made of sandwiched PCBs

Wristwatch made of sandwiched PCBs

Here’s a wristwatch concept we haven’t seen before. Instead of trying to sandwich everything inside of a case it uses a stack of PCBs as the body of the watch . [Mats Engstrom] wrote in to tip us off about his build. The design goes with LEDs which is nothing new. But unlike previous offerings [Mats] didn’t go with one LED for each minute . When the touch sensor in the middle of the watch is activated the twelve LEDs on the face will let you know the hour and the nearest five minutes. A video of this is embedded after the break. The design uses three different circuit boards. The bottom board is the largest and provides slots through which the wrist bands can connect. It also serves as one of the two battery connectors. The second PCB is a spacer with a cutout for the coin cell that powers the device. The top board is where all the magic happens. It’s dual sided to host th...

Full article: http://hackaday.com/2013/04/28/wristwatch-made-of-sandwic...

Tweets

Michael Kors or Rolex wristwatch___? #Design4Li...

twitlonger.com 10 May '13, 2am

REALBENNYSNIPES @BennyCapricon 10th May 2013 from TwitLonger Tweet Michael Kors or Rolex wristwatch___? #Design4Life http:...

One Bitcoin by the numbers: Is there still prof...

extremetech.com 30 Apr '13, 2pm

I remember when they were like a few bucks each, and that was already way ahead in time when bitcoins were getting popular...

@DashTaz

hungrygowhere.com 28 Apr '13, 3pm

My seven-year old daughter used to be really picky about food and would take an hour just to finish a meal (if she even fi...